After all, plate heat exchangers will be blocked due to various factors during use. The dislocation of the deformation will cause problems between the metal plates.??If the plate heat exchanger is normally open, then during assembly and cleaning, if the metal plate is tightly wound, or it may cause damage to the gasket.?You must pay attention to the daily cleaning of plate heat exchangers. This problem will cause us to suffer major losses.??

Hope that the introduction of plate heat exchanger manufacturers can be helpful to you, follow us for more news! If you don’t understand those aspects, you can click to consult us, and we will have professionals to answer you!. It must be paid attention Hanging furnace heat exchanger to when cleaning the plate heat exchanger. How to clean up has become a problem that we must face, so when we encounter plate heat exchangers How do we deal with blockages? Let's follow the plate heat exchanger manufacturers to understand it~?? Let's first understand the consequences of blockage of the lower plate heat exchanger. However, if you climb this situation is not tight, tighten him again,

it may cause leakage, which is a very troublesome problem. This is likely to cause corrosion and scaling of the breakfast plate heat exchanger. If you frequently remove the plate heat exchanger, it will cause the suspension deformation at both ends of the metal plate groove.?? In addition, there is one more thing to note. If the heat exchanger is blocked, the heat exchange efficiency of our plate heat exchanger will be greatly reduced, and it will also affect the normal drop of our cooling water temperature

With the rapid development of small and medium-sized industries, the production of wastewater is inevitable.??The method to increase the logarithmic mean temperature difference of the heat exchanger is to use countercurrent or close to countercurrent mixed flow as much as possible, increase the temperature of the hot side fluid as much as possible, and reduce the temperature of the cold side fluid. There are some fertilizer-producing components in this waste water. For plate heat exchangers arranged in a single process, for easy maintenance, the fluid inlet and outlet pipes should be arranged as far as possible on the side of the fixed end plate of the heat exchanger. It is the best solution for heating the evaporator.